This displays the TIS2000 Installation Mode window.Ħ Select Standalone and then click the Next button. This must be an open COM port where no external devices are connected.
You can optionally click the Browse button to select a different destination directory for the fileĥ Select the serial port to use for the scan tool connection. Note: Clicking the Next button on the Destination Location window places the SPS application in the destination directory C:\Program Files\cosids. This displays the Choose Serial Port window. This displays the Choose Destination Location windowĤ Click the Next button. This displays the Language Selection window.ģ Select a language for the application and then click the Next button. If so, click the NO button to NOT reuse old settings.Ģ Click the Next button to continue.
Note: If the TIS2000 software was previous installed and removed from the PC, a message may appear asking to reuse old settings. The TIS 2000 Installation Welcome window appears automatically.
To install the SPS software, follow these steps:ġ Insert the Application CD into the PC’s CD drive. Install the SPS Application CD software, which includes installing the USB security key (security device). 5 Continue with the steps in the next section, “Install the SPS Software” Windows then installs the protocol automatically. This displays the Connection Properties dialog box (see Figure 1.4 on page 3).Ģ In the Connection Properties dialog box, see if TCP/IP is already listed under “This connection uses the following items.” If not, click the Install button to display the Select Network Component Type dialog box.ģ Click Protocol and then click the Add button to display the Select Network Protocol dialog boxĤ Under Manufacturer, select Microsoft and under Network Protocol, select Internet Protocol (TCP/IP). With the Internet Connections window displayed, right click Local Area Connection and then select Properties (see Figure 1.3). For Windows 2000, right click the My Network Places icon on the Windows desktop.This displays the Connection Properties dialog box (see Figure 1.4 on page 3). With the Control Panel window displayed, select Network and Internet Connections (see Figure 1.1 and Figure 1.2). For Windows XP, click the Window’s Start button, and then select Control Panel.To install the TCP/IP protocol, follow these steps:
These installation steps are for setting up the TCP/IP protocol for first-time, stand-alone users. Step 1: Check and / or Install TCP/IP Protocolĭetermine if TCP/IP protocol is installed on the PC and install if necessary. If YES, go to Step 3: “Update the SPS Data”.
How to install TIS2000 of Tech II to have Service Programming System (SPS) ?īefore you install the SPS application, answer the following question to determine if the SPS application is already installed on the PC: “Is there a TIS 2000 icon on the Window’s desktop?” The computer has to come with Com port.Ħ) The Tech2 clone has to come with one RS232-DB9 adapter shown as below:Īnd make sure one end of RS232-DB9 adapter plug to the computer Com port and another end connect to the Tech2.
So SPS will not able to program ECU for GM 2007 up.Ģ) SPS must work with TIS2000 with USB key. All programming steps are activated and finalized through the PCĬan China clone GM Tech2 scanner support SPS?ġ) TIS2000 does not support 2007+ models. The SPS application programs General Motors programmable control modules by using the Tech 2 Flash scan tool or the Next Generation scan tool as a “pass-thru” device to communicate program data to the vehicle control module. The GM Service Programming System (SPS) is a personal computer (PC) application used to reprogram vehicle electronic control modules (ECMs).